Banvel M - Tips for use and dosage

The Content Of The Article:

Banvel M - Tips for use and dosage: plants

Some lawns tend to tend to promote the growth of all sorts of other plants, making them look like a colorful expanse of all possible growths. Is there a way to get a lawn that looks like a lawn even without hiring an English gardener? Are there miracle remedies that limit the care of the lawn to a tolerable level? One of the powerful lawn weed killers is Banvel M, a remedy that can bring tidiness back to the lawn when used and dosed correctly:

What can the lawn weed killer Banvel M?

Banvel M is a herbicide that accelerates the growth of plants in a way that can not be understood by the nutrient supply. The plant shoots so powerful, without getting nutrients for this growth, this undersupply allows the plant now go down to the roots.
Included are two active ingredients, Dicamba and MCPA. Both growth factor herbicides are taken up by leaves and roots and transported within the plant. After the development of both drugs, it was quickly observed that this growth acceleration does not work for all plants. Only dicotyledonous growth forms such as most of our weeds were compromised while monocotyledonous plants such as grass continued to develop. Thus, the selective herbicide was invented that exclusively dicotyledonous plants such. B. Horsetail, clover and stinging nettles removed from the lawn. Two active ingredients are used to achieve the broadest possible effect on all unwanted plants in the lawn.

Application and dosage of Banvel M

Banvel M contains 30 g / L dicamba (as 34 g / L potassium / sodium salt) and 340 g / L MCPA (as 391 g / L potassium / sodium salt), both as a water-soluble concentrate.
Banvel M may be used on lawns or ornamental turf against dicotyledonous weeds. The application is limited to outdoor and may occur during the growing season from April to September, but not in the seed year. The maximum number of treatments is limited to two per culture per year, with a period of between 28 and 42 days between treatments. Banvel M can be sprayed with the maximum application rate limited to 0.6 ml per square meter in 100 ml of water per square meter. Or it can be applied by pouring, then no more than 0.6 ml per square meter in 1 liter of water per square meter may be used.
This application according to instructions is required by law, even an overdose is threatened by a fine. When Banvel M is applied during a warm and growth-promoting weather, this should accelerate the dying-off of unwanted plants. But you need a little patience: the plants must continue to grow for several days, until the effect of the herbicide occurs.

Good professional practice is still required

The application of pesticides is always provided for after our beginning of the year amended Plant Protection Act, when all non-chemical options have been exhausted. Today priority is given to integrated pest management, in which first of all the expertise that is available to the gardener is to be used.
However, when a lawn is completely overgrown by weeds, a herbicide is often the only means of getting "grounded in the lawn" once. Then Banvel M is one of the herbicides that can be used in the sense of the Plant Protection Act due to its selective effect and protection of the grass plants. Because the plant protection law prescribes to select the herbicide, which purposely eliminates the disturber, if even chemicals are to be used.

Meadow - lawn - grass

The entire right to plant protection is being reformed because the majority of citizens in our society are demanding less chemicals. Therefore, it was now enshrined in the law that crop protection must be carried out in accordance with "good professional practice". In doing so, the legislature has expressed that, as society demands, it ceases to pay attention when gardening is replaced by the use of chemicals.
Here also purely practical experiences are reflected: A lawn that grows on the wrong ground and is improperly maintained, will never become a beautiful lawn even with the constant use of herbicides. Therefore, you probably do not come around for a general examination of the turf general condition for legal and factual reasons, if after the use of Banvel M the weeds cheerfully continue to sprout:

Sick Lawn needs cause research

If weeds are more prevalent, that has causes that should be removed if you want to live in peaceful alliance with your lawn over time. Two different causal complexes can promote the appearance of weeds and should be checked and, if necessary,eliminated: The lawn may not be able to grow properly at the given location because it suffers from nutrient deficiencies or is over-supplied with nutrients because the soil is too low or too high a ph value because the grass is more often exposed to dryness or waterlogging, because the soil is so compacted that the turf can not grow, etc. Or the turf suffers from improper care, which can be expressed in too short a lawn cut, in incorrect irrigation or in mistaken fertilization. Perhaps the entire selected lawn seed mixture does not match the location and stress to which the lawn is exposed.

Beware of the application

Although Banvel M is approved for use in home and garden even after the latest list of pesticides, the active ingredients are not entirely safe:
  • Dicamba is a benzoic acid derivative that is harmful if swallowed, that is likely to cause serious eye damage and is harmful to aquatic life with long lasting effects, according to the EU Hazard Labeling and Hazard Labeling of the United Nations. Accordingly, protective clothing should be worn when handling the active substance, should be rinsed immediately with water in case of contact with the eyes and the doctor advised that release to the environment should be avoided.
  • Similar information is found in MCPA, a phenoxycarboxylic acid, but it is classified as very toxic to long-acting aquatic organisms and also causes skin irritation. Products containing MCPA and their containers should be disposed of as hazardous waste.
  • Both are nerve agents, especially when dealing with MCPA caution is required: A formulation of phenoxyacetic acid was used in the Vietnam War as a defoliant and triggers after a comparative study of the Cancer Registry of Central California with high probability of leukemia. There are scientists who also suspect carcinogenic potential in other formulations of the MCPA family. An overly permissive handling of the permitted maximum amounts and the legally arranged safety regulations is therefore really not appropriate for these active substances.

Video Board: .

© 2019 All Rights Reserved. When Copying Materials - The Reverse Link Is Required | Site Map