Lay heating pipes yourself - instructions & costs


The Content Of The Article:

Lay heating pipes yourself - instructions & costs

If you want to save costs, even when laying heating pipes, you usually try to do all the work on your own. Although sometimes a certain time-related "extra effort" is associated with it, but in the end, it is generally advisable to put on your own hand.
In contrast to earlier times, the laying of heating pipes in favor of the eager handyman has done a lot. For now are (finally) the days when heating pipes were still thick, heavy and unwieldy, and thus the welding and laying work themselves were associated with much time and effort. Reason enough for many do-it-yourselfers, prefer to consult with the specialist right away.
Materials and workers
Today, modern boilers are generally offered with far fewer, but all the more powerful circulation pumps that provide the additional benefit of being easier and less time consuming to relocate.
In general, multi-layer plastic, copper and stainless steel are among the most common materials when it comes to the nature of heating pipes. It should be remembered that piping is an essential aspect of the heating system.
However, the fact is that most of the other components, such as the spa or the gas meter, may only be processed by a qualified heating engineer.
Before it "goes to work", it applies, the required
To purchase materials. These include copper or plastic pipes (measure before!), Hemp for sealing, a soldering gun or a welding machine, solder paste as needed and a pipe cutter.
The relocation
  • At the beginning, the pipe transitions should first be thoroughly cleaned (with solder paste, for example), in order to be able to assemble them accurately afterwards.
  • Then heat the ends and hold the solder at the seam. (Do not forget to cover the walls to keep them against the
    Protect heat generated during soldering.)
  • In the course of the soldering process, the respective end of the tube becomes liquid and contracts slightly inwardly due to the previously applied solder paste. Incidentally, experts advise never to cool the pipes with water after the welding process, because this would lead to permanent leaks or leaks.
  • After only a few seconds, the pipe is already cooled down again so that the work process can be continued. After soldering it is recommended to insulate copper pipes with copper pipes. In this way, no valuable energy is released into the ground. Although plastic pipes do isolate quite well, additional insulation does not in fact harm them.
Additional information
  • The heating pipe is now welded to the radiator and for safety's sake with a little hemp sealed (alternatively, also a permanently elastic sealant) sealed.
  • When laying under the plaster, in or under the screed, it should not be forgotten to position the pipes towards the heating system slightly upwards. So the venting process will proceed smoothly later.
  • It is also advisable to use bends instead of angles. This reduces the noise during the heating process, because the water can flow through the pipes unhindered.
  • When the installation work is completed, a thorough inspection by a qualified installer is essential in any case. Of course, this does not only offer itself for a possible case of damage, but the expert will eventually also the spa - as prescribed - assemble.
Cost of laying heating pipes
The financial expenses for the installation of heating pipes "on their own" amount on average to about 150 to 200 euros. Certainly, the purchase of a welding machine with a cost of about 300 euros is relatively expensive. However, alternatively there is the possibility to lend this for a small fee in the construction trade.

Video Board: HOW TO CHASE PIPES INTO A WALL - Plumbing Tips.

© 2019 EN.Garden-Landscape.com. All Rights Reserved. When Copying Materials - The Reverse Link Is Required | Site Map