Lay stones and plates in a circle


The Content Of The Article:

Stones and slabs are currently the method of choice if you want to secure an area outdoors. Both as a seating area in the garden and as a vehicle parking space you can find stones and plates outdoors.
Special forms and patterns are becoming increasingly popular, with the circular shape being particularly popular here.
If you want to lay the stones or plates yourself and get a circular pattern, then you should be very precise and adhere to an exact guide to achieve a handsome result in the end.
Suitable materials to lay stones and plates in a circle
To get a circular pattern when laying stones and slabs, not all materials are equally suitable. The easiest to handle and thus most suitable are stones and slabs in square shape, followed by rectangles with small size differences in length and width.
The smaller the stones are, the easier the circle pattern can be worked out. For the layman are absolutely unsuitable quarry stones.
Even if you can lay plates and stones with appropriate adhesive and thus permanently attach, so you should rely on the desire for circular laid slabs or stones but rather on the so-called "floating" installation. This granulate is used as a substrate and Rhine sand as a joint filler.
Also indispensable is the attachment of the outer boundaries of the area to be paved with curbs, which must be firmly embedded in the ground.
Lay the procedure for stones and plates in a circle
Whether you want to create a circular pattern with the stones or plates or not, the work always begins with the placement of curbs to give the entire surface a stability and demarcation to the outside. The curbs are placed deep in the ground with liquid concrete, so that after filling the area with granules, the laid stones and the curbs are flush.
If the concrete mass has dried and the edge boundary is therefore stable, the entire area to be paved must be filled with fine-grained granules. It depends on the production of an absolutely straight surface. Now is the time for the actual work - the circular laying of stones or slabs.
Unlike other patterns, the circle does not begin at a corner of the surface, but must focus on the exact center and start laying from there. Just in the middle comes a stone, who wants to set color contrasts can choose this center stone in a different color.
Around this middle stone one begins now with the circle pattern. As close as possible to the middle, two stones with one corner each are placed next to each other, at the free corner towards the middle is the starting point for another stone and so on. So you continue until the entire ring is closed and the last stone touches the free tip of the first stone.
By laying on granules, the individual stones can be corrected again and again until a perfect circular shape is created. The joints between the plates become wedge-shaped wider to the outside, the joints get thicker the larger the plates used.
The second row will be laid the same as the first one, always making sure that the points of contact between two stones are offset from the previous row, ideally at the level of their joints.
In this way you now proceed until the entire area is closed. At the edges of the area, more and more cutting work on the plates becomes necessary.
Once the laying work has been completed, the stone or slab surface must be driven off with a vibrating plate. Finally, the Rhine sand is used. This is spread over several days with a broom on the laying surface and fills the joints tight.

Video Board: How to Lay a Brick Paver Walkway - This Old House.

© 2019 EN.Garden-Landscape.com. All Rights Reserved. When Copying Materials - The Reverse Link Is Required | Site Map