Lilac cut - instructions and time


The Content Of The Article:

Lilac cut - instructions and time: this

Naturally grown wild, the lilac shows its flowers already early in the year, is an ornament for eyes and nose. Corrections usually do not have to be made with him. If the lilac too big or too old, but it makes perfect sense to resort to hedge trimmers. With this measure, the normally easy-care crop needs both the right time and the correct procedure. What to look for is revealed below.

need

A blend of lilac is, as already mentioned, rarely needed. The flourishing enrichment is usually even magnificent, if it is left to itself in this regard. Required or at least advisable, however, is a blending of the lilac in the following cases:
  • Age-related declining flowering power
  • Damaged or dried branches
  • Infested by diseases or parasites
  • Too large dimensions for the location
Tip: Even those who want to prevent the lilac from sowing in an uncontrolled manner in the immediate vicinity, should reach for the scissors.

time

As a rule, the lilac forgives the blend and does not push fast, but strong and tight again. Of course, the conditions at the location must be right. In addition, the date must be chosen appropriately.
Optimal is the cutting of the lilac after flowering, ie in late May or early June. In this way, the splendor must not be waived and the visually disturbing, withered panicles can be removed at the same time on this occasion.
If the waste was forgotten at this time, however, one does not have to wait another year. Whether gentle care cuts and small corrections or radical pruning for rejuvenation - from spring to autumn the measure on easy-care plant is possible at any time. Please note:
  • Frost freedom
  • Dry weather
  • Cut in the morning or in the morning to encourage drying of the cut surfaces
The fresh cut surfaces are quite vulnerable, often attract pests and pathogens magically, allowing them to penetrate easily. The faster they dry, the less the lilac is in danger. It is therefore favorable to carry out the measure in dry and warm or hot weather. If there are already rain clouds or is it sultry, the lilac should not be expected to be blended.
Tip: To ensure that the fresh wounds have dried as far as possible and are therefore closed when it becomes moist again, the time of day is crucial. It is best to cut it in the morning or in the morning so that it can dry out during the day.

Flowering received

Fliederbaum

Lilac forms buds primarily on biennial and older, woody shoots. If these branches are removed mainly or even exclusively, then the flower remains or is at least greatly reduced.
Anyone who wants to correct as well as enjoy the fragrant splendor, therefore always blends only in sections and not the whole lilac at once.

care section

The care cut is quick and easy to perform on lilac. Only the following are removed:
  • Damaged or already dried shoots
  • Blooming panicles
  • Overgrown branches that are balding
  • Inwardly growing shoots
  • Weak, barely leafed shoot
To help lilacs grow more densely, this approach is optimal. In addition, the size and shape can be corrected here. It should be noted, however, that at least a part of the one- and two-year-old branches stops, otherwise the flowering in the following year is puny.

Rejuvenating cut

Lilac drives out of the old wood for a long time, if he finds ideal conditions at the site. Especially if it rarely or even for years is not blended, it shows itself lush and in full bloom. However, it can happen that the plant is aging. The flowering decreases and even the leaves can be a bit light. In this case, a rejuvenating blend is advised.
This is also beneficial if the lilac is too large for the chosen planting place or simply has adopted an undesirable shape. The procedure for the tapered blend of the lilac is as follows:
  1. At a height of about 1.5 meters, the upper area is trimmed first.
  2. Afterwards the pages will be adjusted as desired.
  3. During the penultimate step, the lilac is radically thinned out. All thin shoots are removed, leaving only the stronger, strong branches.
  4. All cut surfaces are smoothed if necessary. For this they can be straightened with a sharp knife, a saw or a mechanical pruner.
Through the procedure from outside to inside it is possible to work very precisely and to give the decorative wood the desired shape.In addition, initially an electric hedge trimmer can be used, since the cut surfaces have to be smoothed or adjusted later anyway.
Anyone who chooses the radical, rejuvenating blend should remember that the flowering starts again after two years.
Tip: A height of one meter should preferably not be exceeded, so that the lilac can drive out vigorously again.

Prevent sowing

When the lilac fades, it starts to sow itself out. If this uncontrolled proliferation is to be prevented, a blending is also advised here. Only the flower spikes are removed for this purpose. Anyone who uses these as cut flowers for the vase, of course, does not have to grab extra scissors.

cutting equipment

As with all other crops, cleanliness is the top priority. It makes sense to disinfect the cutting tools in advance in order to avoid the entry of pathogens. Can be used knife, scissors or saw. Especially the lilac latter is recommended, since the wood is very hard in the first years.
In order to avoid injury or entry ports for parasites and germs by cutting, the blades should be sharp. In this way, neither with frayed surfaces nor bruises can be expected.

proliferation

The head cuttings obtained at the waste of the lilac can be used from a length of 15 centimeters to propagate the plant.

Lilac leaves branch


For this purpose, the lower leaves are removed and the cuttings quickly spent after cutting in soil. However, the success of this multiplication variant is not guaranteed. Better chances are the cutting off of roots or the formation of sinkers.
Conclusion
The lilac is easy to care for and undemanding - and can usually do without a blend. Properly done, however, this measure can lead to a lush growth, increased flowering power or unusual forms. For very old plants, he is even needed to bring the lilac to flower again.

Video Board: How to Prune a Lilac Bush.

© 2019 EN.Garden-Landscape.com. All Rights Reserved. When Copying Materials - The Reverse Link Is Required | Site Map