Weaving balls yourself, tinker


The Content Of The Article:

Wicker balls are a beautiful decoration that adorns the garden all year round. Of course you can buy willow balls, but willow balls braiding itself is much nicer on the one hand and boredom on the other.
Especially on long winter evenings, making the wicker balls is a perfect occupation that will delight every generation.
Which material is used to make wicker balls?
Of course, mainly pastures. This is already revealed by the name. However, pasture is not the same pasture and it also depends on the diameter of the willow balls in the end should have.
The flexibility of the pastures is measured by their diameter. Thin pastures can be correspondingly better bend than thick pastures. If you want to weave a smaller willow ball, you should resort to thinner branches, in a larger willow ball it may be thicker branches.
The most suitable for willow-balls are shoots of basket-willow or silver-willow shoots. The shoots are cut no later than mid-March and processed immediately. If the branches are older than 24 hours, you have to water them again, so that they become pliable again.
Whether the branches are suitable for making wicker balls, can be determined by a bending test. For this you only have to bend a branch around. If it breaks, you can not use this sort of branches.
Braid a concrete manual for willow balls yourself
Below is a tutorial on how to make wicker balls with a diameter of 50 centimeters. From the branches of the pasture you need about an armful. They should have a length of 1.60 meters. Furthermore, you need a secateurs and wire.
Also required: a pot or bucket or a bowl, with a diameter between 30 and 35 centimeters and also holes for draining water, sand, earth and stones.
Once the preparations have been completed, you can now go to practice and start crafting the willow ball. To do this, first place the pot with the stones for more stability and fill it with a mixture of earth and sand. If a planting of the pot is provided, potting soil is filled in the upper third and pressed.
Then one chooses from its bundle of willow branches 5 to 7 branches, which have an equal thickness. They are brought to a uniform length and with the thick end first, a rod is obliquely inserted from outside to inside in the pot until it touches the ground.
At the point of entry, the earth is pressed firmly again before the rod is bent and is also opposite plugged from outside to inside the pot. Firmly press the soil again and bring the other rods into the pot in the same way as the first branch. To reach a round shape, the willow branches are pressed down again and again.
The crossing points are fixed with the wire, which should be covered with plastic. The arches build up from the bottom up. So that no ugly bumps arise, you should make sure that the crossing points are distributed.
When all the rods have been used up, the skeleton for the wicker ball is ready. Now you start with the braiding of the remaining branches. These are interwoven criss-cross between the other branches. Here is always started with the thick end.
To check the shape and correct it if necessary, it is recommended to rotate the ball at regular intervals. The willow ball gets a higher stability, the more rods are woven.
When the ball is done, remove the used wire again. Any protruding ends of branches are cut off. As a final step, pour the earth-sand mixture. In the following you keep the pot with the willow ball wet and administered now and then a little fertilizer. The pot can be planted with flowers or moss.

Video Board: DIY Basteln - Kugeln Bälle aus Draht / Crafts - Tinker Balls with WIRE.

© 2019 EN.Garden-Landscape.com. All Rights Reserved. When Copying Materials - The Reverse Link Is Required | Site Map