Measure window correctly - instructions


The Content Of The Article:

Measure window correctly - instructions

When building a new building, new windows are needed. But also in connection with renovations it often happens that the installation of new windows is indispensable.
Be it because, for example, the old ones in terms of design no longer meet the current requirements; It is because the outdated windows no longer meet the expectations of a good insulation (for example, due to wear and tear et cetera).
In any case, it is worth knowing that future-oriented solutions in terms of insulation & Co. offer impressive savings potential. After all, this allows the temperature controller to be reduced by up to three degrees Celsius.
That makes a heating cost savings of up to 15 percent! Of course, investing in new windows is a bit of a "tricky" cost factor at first, but such a purchase is definitely worth it.
In general - experts advise - it is advantageous to check the functionality of a window every ten to fifteen years. Leaky points "invite" cold and moisture to penetrate into the masonry and cause damage there over many years (serious) or damage.
Measuring new windows is actually easier than you might think. If, for example, the so-called total size is mentioned, then here come the complete dimensions of the window including roller shutter, frame extensions and the
Connection profiles for carrying.
at
an old building, however, looks a little different. It is important to measure from the top edge of the window frame to the window sill in order to compensate for any deviations on both sides.
It also makes sense to deduct one centimeter from the measure thus obtained, in order to achieve this
Connection profile in the lower part of the window, which is indeed behind the windowsill, to include in the calculations. If too large or too small windows are used in the designated wall openings, this can usually lead to considerable problems....
Length, width, height... - easier than expected!
After measuring the window height, the width is measured. This means that the respectively visible width of the frame is measured both in the lower half and in the upper half. Of particular importance is always the smaller size, because it can thus be ensured that the newly delivered window can actually be let into the wall opening.
In this context, the rule of thumb is that an average of two centimeters is deducted from the amount thus obtained. In this way, the correct (order) dimensions of the window can be calculated in any case.
Experienced experts advise to measure the window in any case from the outside. This has the following advantage: in the event that the dimensions of the window in the outer area are greater than those in the dimension inside, it is clear that the new window must be inserted from the outside.
For new buildings, the following rule applies: It is recommended to always deduct two centimeters from the openings. Thus, if the wall opening is 1560 millimeters high and 1660 millimeters wide, then 1560 millimeters high and 1420 millimeters wide are estimated as a measure.
In fact, a precise dimension of the window reveal can not be avoided. For this reason, it is advisable to determine several times the height or the window width. And in each case in the area in which later the window frame should be installed.

Video Board: How to Install a Replacement Window - This Old House.

© 2019 EN.Garden-Landscape.com. All Rights Reserved. When Copying Materials - The Reverse Link Is Required | Site Map