Paper the window properly - instructions


The Content Of The Article:

Paper the window properly - instructions

If the new construction of a house has been successfully completed or the renovation work on a building is finally completed, then it goes now to "preserved": the completion of the interior is pending.
First and foremost, it is now important to carry out the pending wallpapering work professionally, so that no visual abnormalities can be recorded later. Corresponding rework would usually be very difficult in the course of this and are usually associated with additional costs.
Some, relevant things, it is important to note when wallpapering in any case. Clean working and precise "working" should be a top priority in this context. But whoever thinks it is enough to set up a wallpapering table, to buy decorative wallpapers and then to brush them with lots of paste, in order to finally attach them to the walls, is a great mistake.
Wallpapering is not an "art", but nonetheless a usually very time-consuming and time-consuming work, which should succeed if possible already in the "first attempt".
The window often has it...
Especially in the window area is often expected with one or the other "technical" difficulty. Here, for example, a false sense of proportion, an inaccurate cut or even the choice of a low-quality wallpaper can lead to the end result leaves a lot to be desired in retrospect. A forward-looking planning is therefore very important.
A very
Special attention should be given to wallpaper edges in the area of ​​doors and windows. This means that the position of the first lane exactly in advance
is to be determined.
Although the wallpaper can be aligned as far as possible flexible immediately after attachment to the wall using the glue or move to the left or right, however, just in the window area, for example, sideways of roller shutter boxes et cetera usually little room.
Experts know that it makes sense to never let the edges of the wallpapers get exactly onto the soffit. Rather, it is advisable to attach the web in such a way that it is located in front of the window reveal. In the course of this, it is important to press the resulting projection to the ceiling area firmly against the wall - this can best be done with a clean cloth or a brush; Cut over remaining rests with the carpet knife.
Niches and other difficulties
If a niche in the window area is to be lined properly with a wallpaper, it is generally best to start at the left side of the window. In doing so, the previously exactly measured web is laid on the niche and covered with wallpaper.
Experience has shown that it can "end" with frustration and thrill, if instead one would decide to fit the niche with the wallpaper web. It is much simpler and less time-consuming, in fact, to incise the path in the area of ​​the niche above and below and to fold the resulting projection cleanly inwards.
The remaining wallpaper is clean - again with the cutter - cut off. Then follows the rest of the part: the other side or the part located above the window must be covered equally clean.
Simply fold up the following tracks and cover the missing niche area. Even with patterned wallpaper can be continued in this way, the niche colorful and evenly.

Video Board: How to apply Window Film.

© 2019 EN.Garden-Landscape.com. All Rights Reserved. When Copying Materials - The Reverse Link Is Required | Site Map