The Content Of The Article:
- 2 ways to split wood
- Splitting wood - you should pay attention
Splitting wood is a physically difficult job and often leads to accidents. What you should pay attention to when chopping wood, read here.
More and more people are turning to wood for heating because it's just cheaper. Although wood has also become more expensive over the years, it is by no means as expensive as oil and gas.
But before you can use the wood for heating, you have to split the wood to fit in your fireplace.
The best time is actually after the impact. The small pieces dry faster and can be used earlier for heating. In addition, fresh wood can be split better than dried wood.
2 ways to split wood
You have two ways to chop the wood when chopping wood. Many still use a good ax. If you can dig deeper, you can also opt for a log splitter. These are particularly useful if you often have large quantities or split wood several times a year. They are available in different versions with different crown lengths. Also the power and power supply varies with the many models.
Splitting wood - you should pay attention
Tip 1: The right tool
Chopping wood is one of the most strenuous tasks in gardening. But you can make your job a little easier if you pay special attention to your tool. Most probably access a conventional ax. Much more pleasant, however, can work with a real Spaltaxt. Like with the Fiskars splitting ax X27. With her, the wood is only struck. Then it breaks apart wedge-shaped. Can I highly recommend!
You should also have a hammer and a few wedges ready as an aid. Please make sure that hammer and wedge never consist of the same material. So never hit steel on steel. That's because metal shards will fly around your ears.
Tip 2: Check tool for functionality
Before you start splitting the wood, you should always check your tool. Very important is that the ax head sits firmly on the stalk. If this is not the case, fix it immediately. Cracks or damage to the material should also be eliminated.
Tip 3: Wear protective clothing
To prevent accidents, you should wear protective clothing. Very important here are non-slip gloves, so that the ax lies firmly in your hand and does not fly all at once in a stroke.
In addition, you should wear shoes with a steel cap, so that the ax does not slip out of your hand and you disconnect in the worst case a toe. To protect the eyes from splinters, use either safety goggles or a helmet with protective visor.
Tip 4: Use a wooden block
When chopping wood, use a wooden block as a base. If you repeatedly hit the ground and stones, your ax will eventually become dull. There is also a more comfortable height for working. Your back will thank you.
Tip 5: Rightly split wood
You will need less effort to split the wood when you hit the wood fiber with the ax. From time to time, small cracks appear on the wood slit, which you can then take as a small help.
Tip 6: Keep a firm footing
Chopping wood is a really hard job and requires a lot of strength. If you have a firm and right footing to the block of wood, it will make your job a little easier.
Stand approximately with legs spread shoulder width in front of the wooden block. Hold the ax centered with both hands and reach out over the head, then hit the log with full force.
Always make sure that the piece of wood is optimal and safe. Again, accidents often happen because the log can tip over at the last moment and the ax hits at an unfavorable angle.
Tip 7: Keep the tool
When you're done splitting the wood, you should not dump the tool into some corner of exhaustion, but put it properly in place. There should be protection on the cutting edge so that you do not get hurt when removing it later. Oil the cutting edge to protect against rust.
If your ax has become dull over the years, you should have the edge sharpened. So you will be ready to use again quickly.